3,935 research outputs found

    Solitary Waves in Discrete Media with Four Wave Mixing

    Get PDF
    In this paper, we examine in detail the principal branches of solutions that arise in vector discrete models with nonlinear inter-component coupling and four wave mixing. The relevant four branches of solutions consist of two single mode branches (transverse electric and transverse magnetic) and two mixed mode branches, involving both components (linearly polarized and elliptically polarized). These solutions are obtained explicitly and their stability is analyzed completely in the anti-continuum limit (where the nodes of the lattice are uncoupled), illustrating the supercritical pitchfork nature of the bifurcations that give rise to the latter two, respectively, from the former two. Then the branches are continued for finite coupling constructing a full two-parameter numerical bifurcation diagram of their existence. Relevant stability ranges and instability regimes are highlighted and, whenever unstable, the solutions are dynamically evolved through direct computations to monitor the development of the corresponding instabilities. Direct connections to the earlier experimental work of Meier et al. [Phys. Rev. Lett. {\bf 91}, 143907 (2003)] that motivated the present work are given.Comment: 13 pages, 10 figure

    Infusing Problem-Based Learning (PBL) Into Science Methods Courses Across Virginia

    Get PDF
    This article outlines the results of a collaborative study of the effects of infusing problem-based learning (PBL) into K-12 science methods courses across four universities in Virginia. Changes in pre-service teachers\u27 attitudes surrounding science teaching were measured before and after completing a science methods course in which they experienced PBL first-hand as participants, and then practiced designing their own PBL units for use in their future classrooms. The results indicate that exposure to PBL enhances pre-service teachers\u27 knowledge of inquiry methods and self-efficacy in teaching science

    The role of virtual reality in built environment education

    Get PDF
    This study builds upon previous research on the integration of Virtual Reality (VR) within the built environment curriculum and aims to investigate the role of VR and three-dimensional (3D) computer modelling on learning and teaching in a school of the built environment. In order to achieve this aim, a number of academic experiences were analysed to explore the applicability and viability of 3D computer modelling and VR into built environment subject areas. Although two-dimensional (2D) representations have been greatly accepted by built environment professions and education, 3D computer representations and VR applications, offering interactivity and immersiveness, are not yet widely accepted. The study attempts to understand the values and challenges of integrating visualisation technologies into built environment teaching and investigates tutors’ perceptions, opinions and concerns with respect to these technologies. The study reports on the integration process and considers how 3D computer modelling and VR technologies can combine with, and extend, the existing range of learning and teaching methods appropriate to different disciplines and programme areas

    Integrating forage technologies on smallholder farms in the upland tropics

    No full text
    In the past, adoption of forage technologies has been poor. This paper considers the reasons for this low level of adoption and how the situation has changed in recent years. Experiences, mostly in south-east Asia and some in east Africa, have shown that participatory approaches in the development of technology are the key to integration of forages into smallholder upland farming systems. This paper describes how projects went through the formal and informal stages of forage evaluation. Several key characteristics of communities were identified that determined whether forages could have an impact. A participatory approach was developed, which enhanced both forage technology development and its scaling-out to new areas. Some important data were generated on the environmental adaptation of forage varieties. A model for scaling-out forage technologies was developed. There are several stages of forage adoption, in which grass and legume species play different roles. Challenges for the future are to strengthen participatory approaches in the development of technology, especially in the process of scaling-out such developments

    Contamination in complex healthcare trials:the falls in care homes (FinCH) study experience

    Get PDF
    BACKGROUND: Trials are at risk of contamination bias which can occur when participants in the control group are inadvertently exposed to the intervention. This is a particular risk in rehabilitation studies where it is easy for trial interventions to be either intentionally or inadvertently adopted in control settings. The Falls in Care Homes (FinCH) trial is used in this paper as an example of a large randomised controlled trial of a complex intervention to explore the potential risks of contamination bias. We outline the FinCH trial design, present the potential risks from contamination bias, and the strategies used in the design of the trial to minimise or mitigate against this. The FinCH trial was a multi-centre randomised controlled trial, with embedded process evaluation, which evaluated whether systematic training in the use of the Guide to Action Tool for Care Homes reduced falls in care home residents. Data were collected from a number of sources to explore contamination in the FinCH trial. Where specific procedures were adopted to reduce risk of, or mitigate against, contamination, this was recorded. Data were collected from study e-mails, meetings with clinicians, research assistant and clinician network communications, and an embedded process evaluation in six intervention care homes. During the FinCH trial, there were six new falls prevention initiatives implemented outside the study which could have contaminated our intervention and findings. Methods used to minimise contamination were: cluster randomisation at the level of care home; engagement with the clinical community to highlight the risks of early adoption; establishing local collaborators in each site familiar with the local context; signing agreements with NHS falls specialists that they would maintain confidentiality regarding details of the intervention; opening additional research sites; and by raising awareness about the importance of contamination in research among participants. CONCLUSION: Complex rehabilitation trials are at risk of contamination bias. The potential for contamination bias in studies can be minimized by strengthening collaboration and dialogue with the clinical community. Researchers should recognise that clinicians may contaminate a study through lack of research expertise

    Radiation and shielding study for the International Ultraviolet Explorer

    Get PDF
    Technical advisory services to ensure integrity of parts and material exposed to energetic particle radiation for the IUE scientific instruments, spacecraft, and subsystems are provided. A significant potential for interference, degradation, or failure for unprotected or sensitive items was found. Vulnerable items were identified, and appropriate tests, changes, and shields were defined

    Observables in Topological Yang-Mills Theories

    Full text link
    Using topological Yang-Mills theory as example, we discuss the definition and determination of observables in topological field theories (of Witten-type) within the superspace formulation proposed by Horne. This approach to the equivariant cohomology leads to a set of bi-descent equations involving the BRST and supersymmetry operators as well as the exterior derivative. This allows us to determine superspace expressions for all observables, and thereby to recover the Donaldson-Witten polynomials when choosing a Wess-Zumino-type gauge.Comment: 39 pages, Late

    Dynamic Provenance for SPARQL Update

    Get PDF
    While the Semantic Web currently can exhibit provenance information by using the W3C PROV standards, there is a "missing link" in connecting PROV to storing and querying for dynamic changes to RDF graphs using SPARQL. Solving this problem would be required for such clear use-cases as the creation of version control systems for RDF. While some provenance models and annotation techniques for storing and querying provenance data originally developed with databases or workflows in mind transfer readily to RDF and SPARQL, these techniques do not readily adapt to describing changes in dynamic RDF datasets over time. In this paper we explore how to adapt the dynamic copy-paste provenance model of Buneman et al. [2] to RDF datasets that change over time in response to SPARQL updates, how to represent the resulting provenance records themselves as RDF in a manner compatible with W3C PROV, and how the provenance information can be defined by reinterpreting SPARQL updates. The primary contribution of this paper is a semantic framework that enables the semantics of SPARQL Update to be used as the basis for a 'cut-and-paste' provenance model in a principled manner.Comment: Pre-publication version of ISWC 2014 pape

    Dynamics of Line-Driven Winds from Disks in Cataclysmic Variables. I. Solution Topology and Wind Geometry

    Get PDF
    We analyze the dynamics of 2-D stationary, line-driven winds from accretion disks in cataclysmic variable stars. The driving force is that of line radiation pressure, in the formalism developed by Castor, Abbott & Klein for O stars. Our main assumption is that wind helical streamlines lie on straight cones. We find that the Euler equation for the disk wind has two eigenvalues, the mass loss rate and the flow tilt angle with the disk. Both are calculated self-consistently. The wind is characterized by two distinct regions, an outer wind launched beyond four white dwarf radii from the rotation axis, and an inner wind launched within this radius. The inner wind is very steep, up to 80 degrees with the disk plane, while the outer wind has a typical tilt of 60 degrees. In both cases the ray dispersion is small. We, therefore, confirm the bi-conical geometry of disk winds as suggested by observations and kinematical modeling. The wind collimation angle appears to be robust and depends only on the disk temperature stratification. The flow critical points lie high above the disk for the inner wind, but close to the disk photosphere for the outer wind. Comparison with existing kinematical and dynamical models is provided. Mass loss rates from the disk as well as wind velocity laws are discussed in a subsequent paper.Comment: 21 pages, 10 Postscript figures; available also from http://www.pa.uky.edu/~shlosman/publ.html. Astrophysical Journal, submitte
    • 

    corecore